Edit: Waaaaa! I just have too much going on at once to try and smoke food. Thanks for your replies Spindog etc.
I'll just stay up late smoking fish. See what we get.
Wrench stuck in my smoking wheel...
- The Quadfather
- Rear Admiral One Star
- Posts: 3868
- Joined: Tue May 08, 2007 2:27 pm
- Location: Carkeek Park, North Seattle
- Contact:
Wrench stuck in my smoking wheel...
Last edited by Anonymous on Wed Feb 10, 2010 4:03 pm, edited 1 time in total.
"Honey Badger don't care.. Honey Badger don't give a ....."
4r7wHMg5Yjg
4r7wHMg5Yjg
RE:Wrench stuck in my smoking wheel...
Hey Quad, I wouldnt worry about the outside temp, I'd go ahead and start smok'n.
It'll be fine.
It'll be fine.
Cast first, worry later.
RE:Wrench stuck in my smoking wheel...
Did you rinse the dry brine off?
Look for Wannafish A Lure on FaceBook
He said, “Throw your net on the right side of the boat and you will find some.” When they did, they were unable to haul the net in because of the large number of fish.
He said, “Throw your net on the right side of the boat and you will find some.” When they did, they were unable to haul the net in because of the large number of fish.
- The Quadfather
- Rear Admiral One Star
- Posts: 3868
- Joined: Tue May 08, 2007 2:27 pm
- Location: Carkeek Park, North Seattle
- Contact:
RE:Wrench stuck in my smoking wheel...
Yes Toni, I rinsed. I wondered if I rinsed to well though, because I wasn't sure if I was seeing that glaze thing that forms?Toni wrote:Did you rinse the dry brine off?
I just see a couple of dry fillets.
"Honey Badger don't care.. Honey Badger don't give a ....."
4r7wHMg5Yjg
4r7wHMg5Yjg
RE:Wrench stuck in my smoking wheel...
Personally I prefer a cold smoked product as opposed to hot smoked/bar-b-qued/kippered fish. The cure you put on the fish should keep all the nasties at bay and the rest is just drying the fish while adding some smoke color and flavor. Cold smoking is done at 80 to 90 degrees for a longer time, heck it can take days. The key to it is maintaining a steady dry air flow over the fish, this can be achieved through convection or by the use of a fan.
Depending on how heavily you dry cured your fish it sounds like it may be fully cured now and only need a bit of color and flavoring. Cut a test sample and give it a taste. Also, once it is done to your liking get a feel for how firm it is. Once it goes translucent and feels a bit tough, its good to go.
When properly cured the flavor of the brine and spices will have made it into the meat so a thorough rinsing should not effect the flavor.
Depending on how heavily you dry cured your fish it sounds like it may be fully cured now and only need a bit of color and flavoring. Cut a test sample and give it a taste. Also, once it is done to your liking get a feel for how firm it is. Once it goes translucent and feels a bit tough, its good to go.
When properly cured the flavor of the brine and spices will have made it into the meat so a thorough rinsing should not effect the flavor.