So I make my own spin-glo rigs(and will soon be selling some either in the classifieds or on Ebay) and in a batch of spin glo's I bought, I got some of what were described as 'peanuts'. I've tried to find data on the common ways these are rigged etc, and can't seem to find much if anything about them. The strange thing about them is that the hole for passing your line through does not run through the center of the float, but starts in the middle of the flat 45 degree angle surface and exits at the little nubbin you can see on the float's bottom as you can see in the picture above. Maybe they are referred to by a different name, or are used primarily in a different part of the country. Can anyone give me some help here?