Northwest Fishing Reports

Got my new boat home on sat, I have exactly 1" on each side going through the door and not much more on the front/back when it is in. Sure looks nice and shiny though.

https://ibb.co/0ZKHTDk

This is the best I could do for image, tried various ways but could not get the picture to show up in the post

You may or may not be familiar, but after you post the thread, go back to view the thread, in the upper right click on edit.
When it re-opens go down below your post and click on add attachments. If they fail due to size, then you will have to resize them. You can also set your phone or camera to take a reduced size image that is easier to work with.

I wish I had a garage but 1" per side would make me very nervous, lol

I tried resizing the image down to almost thumbnail size (100x75) and it still says file size too large

Nice boat. Did you get that at Verles? I bought an 18' Weldcraft Angler last year, and the dealer put a swing tongue on the trailer to help fit it into my garage. If yours doesn't have one, that would help with the length issue.

Yes I purchased at verles. Great dealer. I also have tge swing tongue.

I fixed that problem by getting a bigger garage and garage door.

beeman wrote: ↑

Sat Mar 30, 2019 8:26 pm

Yes I purchased at verles. Great dealer. I also have tge swing tongue.

I bought my Weldcraft at Pacific Marine Sales in Olympia. Great boat, and about $5K less than the same thing in a Hewescraft in Shelton.